Maintenance of 3w and 5w UV laser marking machines

For UV laser marking machines, 3w and 5w are common types of equipment. 3w and 5w UV laser marking machines are constantly developing, but long-term use will also cause some damage, which is also a common problem for every machine. However, if we do a good job of maintenance, it will not be so easy to damage the machine. Therefore, during the application of the machine, if some common faults occur, we need to do some appropriate operating methods to maintain the machine.

Next, let's talk about the maintenance of 3w and 5w UV laser marking machines. As industrial equipment and machines, these are still indispensable. If the maintenance work is done well, the service life of the machine can be increased, and the failure of the machine during normal operation can be reduced, thereby improving our work efficiency.

First, when we use the machine, we must pay attention to whether the height of the lifting mechanical slide rail on the workbench has changed due to deviation. If so, we must remember to adjust it to the correct height. In addition, before using it, we should clean the scene in the correct way. It is recommended to clean it with some small towels dipped in ethanol and wipe in one direction. Secondly, it is the main chassis of the UV laser marking machine. The main chassis is a very important part and needs to be cleaned regularly. The manager can blow along the sub-tube layer. Remember, don't clean it with water, because there are still circuit boards inside, and it will be bad if a short circuit is caused.

In addition, before we start the machine, we need to check whether our mobile phone settings have changed. We must follow the instructions and the correct process for actual operation. During the operation of the equipment, the UV laser marking machine must pay attention to the damage of the power supply and wires. If this happens, we must avoid repairing the power supply and wires first, otherwise it will cause a short circuit or even a more serious disaster.

Then the server computer. This is a place that many people ignore cleaning, but it often needs cleaning. During the cleaning process, try to work with one hand to prevent the current and the body from generating a flow loop and causing harm to the body. Usually, you should always check the condition of each accessory of the machine, including the operation of the display light and the heat fan. If you find that the equipment is faulty, you must deal with it in time.

The above is some tips on the maintenance of 3w and 5w UV laser marking machines! I hope it will be helpful to everyone.