EN

More: 13710252340

Plastic laser welding machine_Laser die cutting machine_Automatic laser engraving [Laiser Laser]

热搜词: 塑料激光焊接 激光打标机 请输入您想要了解的设备关键词……

首页 > NEWS > Industry News

Judging equipment failure through laser cutting laser equipment minor problems

Release time:2021-10-14 17:05:02

【summary】

Laser cutting machine is a relatively precise mechanical processing equipment, any small problem will lead to the performance of the whole equipment, so the whole production and assembly process of laser cutting machine manufacturers is very strict. In addition, after the whole laser cutting machine equipment is produced, it will be debugged and operated to test the stability of the equipment, and occasionally some big problems will inevitably occur.

Laser cutting machine is a relatively precise mechanical processing equipment, any small problem will lead to the performance of the entire equipment, so the entire production and assembly process of the laser cutting machine manufacturer is very strict. In addition, after the entire laser cutting machine equipment is produced, it will be debugged and operated to test the stability of the equipment, and occasionally some small problems will inevitably occur. Let's analyze the failure of laser cutting machine through some small problems.

Judging equipment failure through laser cutting laser equipment minor problems(图1)

A. The burrs are serious when laser cutting sheet metal. In this case, first analyze whether the laser power is up to standard, then check whether the laser works normally, and then debug correctly. Secondly, analyze whether the focus of the laser cutting machine is accurate, and then adjust it according to the offset.

B. The laser cutting machine cuts opaque workpieces. In this case, first check whether the reflector is intact or has stains, which directly affects the conductivity of the laser. Secondly, check whether the laser tube has attenuation marks. If the energy is not up to standard, it will have a great impact on the cutting performance. Remember to replace it in time.

C. The beam shakes when the laser cutting machine is running. The probability of this clarity is relatively low. Generally speaking, this situation is caused by lax manufacturing process. A large part of the reason is that the slider gap is too large and the motor and driver are in poor contact, which should be handled and resolved in time.


Previous: Can thin films on metal surfac

Next:New laser welding technology i